Fadini Divo 71 4 button 433 MHz gate automation transmitter

Replaces the Fadini Astro 43/2 Piccalo and the Fadini Jubi 433 small.

• 4 button = 4 channels
• Rolling code
• Self-learning
• 433 MHz frequency
• Up to 120m range
• Up to 2 years battery life from 3V CR2032 battery
• Dimensions  =  75 x 45 x 11mm

Available in 4 colours

• Mustard yellow
• Lime green
• Lilac candy
• Skyline grey

REPLACING AN ASTRO 43 TRANSMITTER WITH A DIVO 71 TRANSMITTER

• To check that the DIVO 71 is set to the ASTRO43 range hold down buttons 3 & 4. If the LED flashes once then it is on the correct range. If it flashes 3 times continue with the below instructions

SETTING THE DIVO 71 TO THE ASTRO 43 RANGE

• To code the DIVO 71 to be compatible with the ASTRO 43 press buttons 1 & 4 together for 5 seconds. The LED should flash once. If it flashes 3 times repeat the operation until it flashes once. The Divo 71 is now ready to code.

DUPLICATING A DIVO 71 FROM A CODED ASTRO 43

• Press and hold button 1 and then press button 2 twice. Keep button 1 pressed until the LED flashes 3 times (approx 5 seconds).The LED will then stay on solid.
• Place the pre coded ASTRO 43 next to the DIVO 71 and press and hold any button on the ASTRO 43 until the Divo led flashes 3 times ( approx 5 seconds).
• Carry out the same operation for any additional DIVO 71.

CODING A DIVO 71 DIRECTLY ONTO AN ASTRO 43 RECEIVER CARD

• Ensure all dip switches on the ASTRO 43 receiver are in the off position (down).
• Power the ASTRO 43 receiver.
• Put dip switches 1 & 5 on.
• Hold down the button on the DIVO 71 that you want to use to open the gate until the receiver LED flashes on and off.
• Repeat the task for any additional DIVO 71.
• Put dip switches 1 & 5 back to the off position. The led will flash 5 times to confirm programming is completed.